By Ralph Whitley, Sr.
May 17, 2010
Mr. Bunker at Brenelle Enterprises, Inc. in Texas was contacted, and he also agrees that insertion of perhaps an 18 inch pipe using the patented idea from Brenelle on their JET SWET configuration using 18 inch flow through thick wall pipe and ball valve with flange would SEAL THE INTERIOR OF THE 21 INCH OUTSIDE DIAMETER RISER PIPE. One thing he would need immediately is to know the INSIDE DIAMETER OF THE RISER PIPE in order to get the patented idea made with even 18 inch heavy wall pipe.
We discussed the fact that BP through a ROV could cut CLEAN AROUND THE PIPE WHERE YOU HAVE INSERTED A 6 INCH PIPE TO COLLECT OR DRAIN OFF OIL AND GAS PERHAPS. Such would allow a clean opening NOT BENT to be the next challenged insertion point with TAPERED STEEL WASHERS POINTING TO THE ENDS AND HUGE RUBBER COMPRESSION ITEMS IN BETWEEN WITH STEEL PLATING WELDED ON THE UPSTREAM SIDE THEN SPECIAL THREADED SECTION CLEAR OF THE DOWNSTREAM WASHER WHERE THE ROV ASSISTING CAN TWIST RIGHTLY TIGHTY TO SEAL THE INTERIOR OF THE PIPE WHILE ALLOWING FULL FLOW TO CONTINUE DOWNSTREAM THROUGH A FLANGE WELDED ON THE PERHAPS 18 INCH PIPE WHICH WOULD ALLOW A BALL VALVE AND ANOTHER FLANGE TO FLANGE CONNECTION MADE UP. THEN YOUR RISER COULD BE FITTED WITH A WATERPROOF SEAL AREA FLANGE TO BALL VALVE THEN ONCE REMOVING THE WATERPROOF SEAL AND ATTACHING, OPEN TO THE FLANGE THE OPTION WOULD BE TO TAKE 18 INCHES OF OIL AND GAS TO THE SURFACE AND ALSO BE ABLE TO SEAL THE LINE LATER.
NOW AS BEFORE....I WOULD ENCOURAGE EACH OF YOU TO CONSIDER USING THE CUT PIPE SECTION TO PUSH A SLEEVED ITEM TO BE ABLE TO ATTACH L SHAPED STEEL TO HOLD THE ENTIRE 18 INCH PIPE IN PLACE....ALL CAN BE DONE IN 8 HOURS FLAT!
Brenelle will be given other messages pertinent to this idea so they can help ALL seal this leak as one works, two can be added then entire well secured from leaks UNDERWATER at sea floor with contents pumped to the surface of SHUT DOWN at your leisure.